Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to Upgrade Hytera Radio firmware - MD782 MD652 PD782 X1P
#1
MD782 Mobile. (Normal USB-Cable)
  • Simultaneously hold Microphone hanger against a blank part of the transceiver case, push PTT and power on the transceiver.
  • Release PTT.
  • The big Knob lights red.
  • Disconnect the Microphone and connect the USB-cable.
  • Run the upgrade software
  • Connect the transceiver to PC.
  • Click “UPGRADE”.
  • The software will do the rest.
  • After the upgrade has finished, power off the device and disconnect.
 
MD782 Mobile. (USB-Cable with switch)
  • Check the two-position switch on the USB-cable.
  • Set the switch to “DL” for software-upgrade.
  • Run the upgrade software
  • Connect the device.
  • Power on the device.
  • Click UPGRADE.
  • The software will do the rest.
  • After the upgrade has finished, power off the device and disconnect.
  • Set the switch to “CPS” to read or write the RCS file.
  • Run the CPS software.
  • Connect the device.
  • Power on the device.
  • Read from or write to the device.
 
MD652 Small Mobile. (USB-Cable with switch)
  • Check the two-position switch on the USB-cable.
  • Set the switch to “DL” for software-upgrade.
  • Run the upgrade software
  • Connect the device.
  • Power on the device.
  • Click UPGRADE.
  • The software will do the rest.
  • After the upgrade has finished, power off the device and disconnect.
  • Set the switch to “CPS” to read or write the RCS-file.
  • Run the CPS software.
  • Connect the device.
  • Power up the device.
  • Read from or write to the device.
 
PD782 Portable.
  • Connect the USB-cable to the transceiver.
  • Press PTT, TK (orange knob on top) simultaneously and power on the device.
  • Run the upgrade software
  • Connect the device to PC.
  • Click UPGRADE.
  • The software will do the rest.
  • After the upgrade has finished, power off the device and disconnect.
 
X1P High-end portable
  • Check the two-position switch on the USB-cable.
  • Set the switch to “DL” for software-upgrade.
  • Run the upgrade software
  • Connect the device.
  • Power on the device.
  • Click UPGRADE.
  • The software will do the rest.
  • After the upgrade has finished, power off the device and disconnect.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)